NOTE: Admin fingerprint and user fingerprint must be different.

Admin Setup

1. Place remote close to scanner
   • Keys on remote will not beep if you are too far away
   • NOTE: The red light will flash to signify that it is ready to program. You will also hear an audible beep after each step. If you do not hear a beep it means that it did not complete the step properly.
2. Press * (Red light will come on and stay solid)
3. Enter 1 2 3 4 5 6 (Light will turn purple)
4. Press *1
5. Place finger on pad 2 times
6. Take finger off and light will stay blue if successful

User Setup

1. Admin (Light will turn purple)
2. Enter ID # (1-4 digits on remote)
3. Register fingerprint (input 2 times)
4. If successful, light will turn blue
5. Press # to exit

At any point you may add additional users by following the same process of placing a finger on the pad for 2 beeps and then pressing # when done.